top of page

New Shingles and a New TPO Low-Slope Roof in Northwest Spokane

Writer: Ethan Rhoades
Ethan Rhoades
Nov 8
1 min read

Updated: Nov 8

Northwest Spokane, WA · GAF Timberline HDZ + GAF TPO · July 2026

Someone had laid TPO right over the old shingles on the low section, and it was wearing through from underneath. The shingle side had its own problems: granule loss, bad flashings and not enough attic airflow. On the flat part, we tore off the TPO and the shingles under it, put down recovery board and installed new GAF TPO with heat-welded seams. On the shingle side we pulled the power vent, added intake and closed up the old vent holes with new decking. We moved the power mast support out of the valley too, then finished with GAF Timberline HDZ and new chimney flashing.

Recovery board fastened down before the TPO
Recovery board fastened down before the TPO
Finished white TPO meeting the new shingle roof
Finished white TPO meeting the new shingle roof
Finished GAF Timberline HDZ slope over the street
Finished GAF Timberline HDZ slope over the street
Finished TPO field with welded seams
Finished TPO field with welded seams
TPO pipe boot flashing detail
TPO pipe boot flashing detail

Flat and sloped roof on the same house? We do both.


Comments


bottom of page