top of page

R&R Heating: Nine New Skylights and a Tight Metal Roof

Writer: Ethan Rhoades
Ethan Rhoades
Nov 10
1 min read

Commercial case study · North Spokane · Skylight replacement and metal roof fasteners · 2026

The problem

R&R Heating's two metal buildings had old skylights and worn-out fasteners. Those are two of the most common leak spots on any metal roof.

What we did

We pulled nine old skylights, cleaned and repaired each opening and installed nine new ones with new fasteners, closures and sealant. On both buildings we pulled every old fastener and replaced it with a new, larger one. On the main building we also took off the snow breaks and taped over the old holes before the new fasteners went in. Every pipe and vent was cleaned, primed, wrapped with three courses of fabric and coated. We finished by replacing about 50 feet of gutter in a matching color.

Before: the old metal roof
Before: the old metal roof
During: crew setting a new skylight
During: crew setting a new skylight
During: flashing a new skylight
During: flashing a new skylight
During: new, larger fasteners installed
During: new, larger fasteners installed
After: pipe and vent flashings sealed and coated
After: pipe and vent flashings sealed and coated
After: new skylights installed
After: new skylights installed
After: finished roof with new skylights
After: finished roof with new skylights

The result

New skylights, tight fasteners and sealed penetrations on both buildings, finished in August 2026.

Metal roof leaking at the screws or skylights? That's what we fix. Free inspection.


Comments


bottom of page